Vision Operator’s Manual (v12.0 MD) Control Panel Introduction • Ops 2–13
This completes the method for resetting an individual MLE from the Effects Memory Module.
Resetting From the Positioner Module
You can also reset the Crosspoint Group individually from the Positioner Module. This allows
you to reset an MLE or an Aux bus, depending on what is assigned to the Crosspoint Group.
Use the following procedure to reset a Crosspoint Group from the Positioner Module:
1. Press and hold the SEL button on the Crosspoint Group that you want to reset. Refer to
the section “Panel Row” on page Ops 4-5 for more information on the Crosspoint
Group.
2. Press the CLEAR button on the Positioner Module. The Crosspoint Group will return
to the default state.
This completes the procedure for resetting an individual MLE from the Positioner Module.
For More Information...
• on the Positioner Module, refer to the section “Using the Positioner” on page Ops 4-37.
Full Restart
This function performs both a hardware and a software reset simultaneously. Switcher memory
registers, personality registers, installation registers, and custom control registers are not affected
by the reset, but all other switcher parameters (for example, the current state of the panel) are
reset. BLACK will be selected on all buses.
A full restart can only be performed from the Master Panel in a MultiPanel application.
Important — It is not recommended to reset the frame by turning the power off and then on
again, as this may damage the hard disk.
Use the following procedure to perform a full restart of the switcher:
1. Navigate to the System Shutdown Menu as follows:
• Press HOME B More B System Shutdown.
System Shutdown Menu
Note — The control panel will not start up properly if there is a USB flash drive in the USB port
on the control panel. You must remove the USB flash drive from the USB port on the control
panel before powering the control panel up.
2. Press Restart.
To Next Page
Loading...
