Ops 9–4 • Still-Store Vision Operator’s Manual (v12.0 MD)
5. Press Select on the Select Still Menu 1-2 to select the still and have it loaded.
This completes the procedure for loading a still into a still-store channel.
Assigning a Default Still
Each still-store channel can have a default still that is loaded automatically when the switcher
starts up. This allows you to have the stills that you most commonly use always loaded into the
still-store channels when you start the switcher up.
Use the following procedure to assign a default still:
1. Navigate to the Still-Store Menu as follows:
• Press HOME B Effects B Still Store.
Still-Store Menu 1-2
2. Load the still you want to set as default into the Global-Store you want it in. This is the
channel that the still will be automatically loaded into.
Operating Tip — You can press View Defaults to check what is currently set as the default
stills for the Global-Store or MLE-Store channels.
3. Press Assign as Default on the Still-Store Menu 1-2 to assign the current still as the
default for the selected channel.
This completes the procedure for assigning a default still.
Viewing/Clearing Still-Store Cache
You can view what still-store images are currently loaded into cache or remove a currently loaded
still to free up space. Removing a still from cache does not delete the still.
Operating Tip — You can clear the still currently loaded into a channel by selecting 0 as the
still number you load from the keypad on the Global Memory Module.
Use the following procedure to remove a still from cache:
1. Navigate to the Still-Store Menu as follows:
• Press HOME B Effects B Still Store B More B View Cache.
To Next Page
Loading...
