Vision Operator’s Manual (v12.0 MD) Peripheral Control • Ops 10–3
External Still Store Interface Control
The Vision switcher interfaces with external still-store devices using the Intelligent Interface
protocol. You can load different stills that are stored on the external still-store device directly
from the switcher using the still number.
To load a still from the control panel, you must have communications with the external still-store
device set up on the switcher, as well as the input BNC on the switcher that is connected to the
device assigned to the external still-store.
Use the following procedure to load a still:
1. Select the crosspoint button on the crosspoint bus that has been mapped to the input
BNC for the external still-store. The display on the Effects Memory Module for the
crosspoint group will show the current Still ID and Still Channel that are assigned to
that input BNC.
2. Use the keypad in the center of the module to enter the number of the still you want to
load.
3. Press ENTER on the Effects Memory Module to load the still.
This completes the procedure for loading a still.
To Next Page
Loading...
