Vision Operator’s Manual (v12.0 MD) Position/Crop Functions • Ops 13–13
Locate
The Locate feature allows you to move the channel and viewpoint together. This feature is used
when you want to move the channel without changing its appearance or shape. With this feature
enabled, the apparent angle of the channel is always the same, so there is no change in perspective
when the channel is moved in 3D space.
The graphic in the Viewpoint area of the menu displays the location of the viewpoint in relation to
the viewable area.
Use the following procedure to adjust the position of the channel and viewpoint:
1. Press the SEL button on the Keyers Module for the Keyer that you want locate the
channel for. The S&T MD Position/Crop Menu 1-2 is displayed. The key must already
be flying.
2. Press More B Advanced Positioning on the S&T MD Position/Crop Menu 2-2.
3. Press Locate on the S&T MD Advanced Positioning Menu.
Locate — S&T MD Advanced Positioning Menu
4. Adjust the position of the channel as follows:
•Use the X Locate knob on the S&T MD Advanced Positioning Menu to move
the viewpoint and channel right or left along the X-Axis.
•Use the Y Locate knob on the S&T MD Advanced Positioning Menu to move
the viewpoint and channel right or left along the Y-Axis.
This completes the procedure for adjusting the position of a channel and the viewpoint.
To Next Page
Loading...
