Ops 17–30 • WARP Effects Vision Operator’s Manual (v12.0 MD)
Split WARP
The Split WARP allows you to split the key in half and move both halves away from each other in
opposite directions.
Use the following procedure to set up a Split WARP:
1. Select and activate the Split WARP effect on the keyer you want to apply it.
2. Press Position on the S&T WARP Menu.
Split (Movement) — S&T WARP Menu
3. Adjust the movement of the effect as follows:
•Use the Movement knob on the S&T WARP Menu to select the direction of the
movement of the two pieces.
•Use the Amplitude knob on the S&T WARP Menu, or the positioner, to adjust the
amount of distance between the two pieces.
4. Adjust the axis of the effect as follows:
• Press Axis on the S&T WARP Menu.
Split (Axis) — S&T WARP Menu
•Use the Position knob on the S&T WARP Menu, or the positioner, to adjust the
position of the split between the two pieces.
•Use the Angle knob on the S&T WARP Menu, or the positioner, to adjust the
angle of the split between the two pieces.
This completes the procedure for setting up a Split WARP.
To Next Page
Loading...
