Ops 5–14 • Transitions Vision Operator’s Manual (v12.0 MD)
Figure 5.21 Video Sources Selected — After Transition
This completes the procedure for performing a fader transition.
For More Information...
• on setting up a wipe transition, refer to the section “Wipe Transitions” on page Ops 6-3.
• on setting up for a Squeeze & Tease transition, refer to the section “Using Squeeze &
Tease MD Wipes and Sequences” on page Ops 15-13.
Performing an Auto Transition
An auto transition is performed by pressing the AUTO TRANS button on the Transition
Module or Keyers Module. From the Transition Module you can transition multiple keyers,
plus the background. From the Keyers Module, you can only transition each keyer individually.
The speed at which the transition is performed is determined by the MLE or Key rate. Refer to the
section “Transition Rates” on page Ops 5-9 for more information.
Note — Key transitions are performed in the same way as Background transitions. To perform
a key transition, select the video sources you want on the Keyer bus, and select the keyer on
the Transition Modules.
Use the following procedure to perform an auto transition:
1. Select a video source on the Background bus of a Program/Preset MLE. This is the
on-air video signal.
Note — If a non-synchronous source is selected on a crosspoint bus, the crosspoint button
flashes, indicating that the source is mis-timed. Refer to the section “Non-Sync Detection” on
page Eng 7-9 for more information non-sync detection.
2. Select the video source that you want to transition to on the Preset bus of the same MLE
(Figure 5.22).
Figure 5.22 Program/Preset Bus
3. Select BKGD as the next transition selection on the Transition Module (Figure 5.23).
The BKGD button will be lit and the video source selected on the Preset bus will be
shown on the Preview output.
SEL
Background Bus
Keyer Bus
Preset Bus
SEL
Background Bus
Keyer Bus
Preset Bus
To Next Page
Loading...
