Ross Vision - Page 111

Vision Operator’s Manual (v12.0 MD) Transitions • Ops 5–13
Figure 5.18 Video Sources Selected — Before Transition
3. Select BKGD as the next transition selection on the Transition Module (Figure 5.19).
The BKGD button lights up and the video source selected on the Preset bus is shown on
the Preview output.
Operating Tip — Double-press the BKGD button to select background and all of the on-air
keys. The Double-Press BKGD personality option must be set to Trans Clean.
Figure 5.19 Background Transition — Transition Module (4-Keyer Shown)
4. Select the transition type that you want for this transition. In this example, a Dissolve
(DISS) is selected (Figure 5.19).
5. Move the fader from one limit to the other to perform the transition. The progress bar to
the left of the fader handle shows your progress through the transition (Figure 5.20).
Figure 5.20 Performing Transition — Transition Module (4-Keyer Shown)
6. After the transition is complete, notice that the video sources you selected on the
Background and Preset buses have swapped, or flip-flopped (Figure 5.21). What was
on the Preset bus is now on the Program bus.
SEL
Background Bus
Keyer Bus
Preset Bus
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
CUT
AUTO
TRANS
KEY 3 KEY 4
BKGD
T RANSITION
KEY 1 KEY 2
FRAMES
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS
ROLL
CLIP
WIPE DVE SEQ
CUT
AUTO
TRANS
KEY 3 KEY 4