Ops 18–2 • Appendix A: Pre-loaded Effects Vision Operator’s Manual (v12.0 MD)
Squeeze & Tease MD Wipes and Sequences
This section provides descriptions of the pre-loaded Squeeze & Tease wipes and sequences that
are provided with the Vision software.
Table 18.1 Squeeze & Tease MD Wipes and Sequences
Number Name Description
00 PageRoll Roll Down from Top Right to Bottom Left
01 LensFlar Lens flare from Top Left to White Flash
02 Ripple Liquid Ripple out from Center
03 Melt Melt down
04 PixyDust Pixelate out with animation
05 Globe Shrink to Globe and Roll off Left
06 Heart Shrink to Heart with border and Fly back to Top Right
07 Sandstrm Roll over Left to Right with Transparency and Melt
08 Stretch Stretch Horizontally to Black
09 HorzSplt Split in Center and Halves move out
10 PushLt Push Left
11 PushRt Push Right
12 PushUp Push Up
13 PushDn Push Down
14 PushUpLt Push to Upper Left Corner
15 PushUpRt Push to Upper Right Corner
16 PushDnLt Push to Lower Left Corner
17 PushDnRt Push to Lower Right Corner
18 RotateX Rotate in the X-Axis to a Knife Edge
19 RotateY Rotate in the Y-Axis to a Knife Edge
20 SwingRt Pivot Point on Right Edge, Rotate in X-Axis to the Right and Back
21 SwingLt Pivot Point on Left Edge, Rotate in X-Axis to the Right and Back
22 SwingUp Pivot Point on Top Edge, Rotate in Y-Axis Up and Back
23 SwingDwn Pivot Point on Bottom Edge, Rotate in Y-Axis Down and Back
24 SwngUpLt Pivot Point on Top Edge, Rotate Up and then Left
25 SwngUpRt Pivot Point on Top Edge, Rotate Up and then Right
26 SwngDnLt Pivot Point on Top Edge, Rotate Down and then Left
27 SwngDnRt Pivot Point on Top Edge, Rotate Down and then Right
28 RotXBack Push away while Rotating in the X-Axis
29 RotYBack Push away while Rotating in the Y-Axis
30 DiveRt Rotate Back and Right
31 DiveLt Rotate Back and Left
To Next Page
Loading...
