Ops 10–10 • Peripheral Control Vision Operator’s Manual (v12.0 MD)
Router Matrix Control
The Vision switcher allows you to control the source selection for a router that is controlled from
the switcher. Source changes are made by selecting the crosspoint button that is assigned to the
router, and then selecting the new router source on the Matrix Control Menu.
You can also access the Router Matrix Control Menu by pressing the crosspoint button
assigned to the router you want to control.
Use the following procedure to change a router source:
1. Navigate to the Remote Control Menu as follows:
• Press HOME B Effects B More B Remote Ctrl Select.
2. Press Router Control on the Remote Control Select Menu.
3. Use the BNC knob on the Remote Control Select Menu to select the output of the
router you want to change the source for.
4. Press GO!! on the Remote Control Select Menu.
Note — If the switcher does not receive a response from the router in over 2 seconds, the
switcher will report the communications with the router has been lost. Double check the cable
connections and that the router is operational.
Router Matrix Control Menu
Operating Tip — The Refresh Sources button allows you to poll the selected router for the
list of available sources on it. If your router does not support Router Mnemonic names, the
default Src and Dest designations will be used.
5. Use the x1, x10, or x100 knobs on the Router Matrix Control Menu to select the
router source that you want to assign to the selected BNC. The x10 and x100 knobs
allow you to move through the list 10 and 100 items at a time.
This completes the procedure for changing a router source.
To Next Page
Loading...
