Ops 10–2 • Peripheral Control Vision Operator’s Manual (v12.0 MD)
GPI Interface Control
The GPI interface allows the Vision switcher to be controlled by external GPI signals. The status
of the GPI Interface is shown on the Main Menu under Remote Enables and can be turned on or
off from the Remote Enables Menu.
Use the following procedure to turn the GPI Interface on or off:
1. Navigate to the Remote Enables Menu as follows:
• Press HOME B More B Remote Enables.
Remote Enables Menu
2. Toggle GPI on the Remote Enables Menu to On to allow GPI pulses to control the
switcher, or Off to turn off the GPI Interface.
This completes the procedure for turning the GPI Interface on or off.
For More Information...
• on setting up standard GPI, refer to the section “Standard GPI Setup” on page Eng
12-9.
To Next Page
Loading...
