Vision Operator’s Manual (v12.0 MD) Squeeze & Tease Sequences and Wipes • Ops 15–11
Operating Tip — Refer to the section “Using the Naming Menus” on page Eng 5-16 for
more information on using the Sequence Name Menu to enter a name.
5. Enter the new name for the sequence in the New Name field. The name can be no more
than 8 characters in length.
6. Press Accept New Name on the Sequence Name Menu to store the new name.
This completes the procedure for saving and naming a sequence. Once you have saved the
sequence, you can assign it to one of the pattern buttons so that it can be easily selected when you
press the DVE button on the Transition Module.
For More Information...
• on performing a DVE transition, refer to the section “Wipe Transitions” on page Ops
6-3.
• on copying sequence to the switcher, refer to the section “Copying Sequences to the
Switcher” on page Ops 18-5.
Loading a Sequence
You can load a sequence into a keyer either for editing, or so that you can run the sequence on that
keyer. You can set a default sequence rate that is used when an MLE, or the switcher, is defaulted.
This rate overrides the duration stored in the sequence.
Use the following procedure to load a sequence:
1. Press Load/Save Sequence on the S&T MD Sequence Menu 1-2.
S&T MD Sequence Load/Save Menu
2. Use the Sequence knob on the S&T MD Sequence Load/Save Menu to select the
sequence you want to load. Only registers with a green dot next to them contain
sequences.
Operating Tip — You can delete the currently selected sequence by pressing Delete
Sequence on the S&T MD Sequence Load/Save Menu. This clears the sequence from the
currently selected register.
3. Press Load Sequence on the S&T MD Sequence Load/Save Menu to save the
sequence to the selected register.
This completes the procedure for loading a sequence.
To Next Page
Loading...
