Ross Vision - Resetting the Switcher; Software Reset

Vision Operator’s Manual (v12.0 MD) Control Panel Introduction • Ops 2–11
Resetting the Switcher
If required, the Vision switcher can be reset from the control panel. This can be either a software
based reset, or a restart of the entire switcher.
• Software Reset — A Software Reset affects software only, returning the switcher to the
default state.
• Full Restart — The Full Restart affects hardware and software simultaneously,
physically powering down the switcher and powering it back up again.
For More Information...
• on shutting down the switcher, refer to the section “Powering Down the Switcher” on
page Eng 4-3.
• on restarting the control panel, refer to the section “Control Panel Restart” on page Eng
4-26.
• on the control panel power supplies, refer to the section “Control Panel Power Supply”
on page Eng 18-9.
• on the frame power supplies, refer to the section “Frame Power Supply” on page Eng
18-11.
• on completely shutting down or powering up the switcher, refer to the section “Powering
Up and Powering Down the Switcher” on page Eng 4-2.
Software Reset
The software reset function can be performed from either the Global Memory System Module
or any individual MLE Memory System Module on the control panel. Both methods are
described below.
Resetting from the Global Memory Module
From the Global Memory Module you can reset either all of the MLEs assigned by your control
panel at once, or each one individually.
Use one of the following methods to reset MLEs from the Global Memory Module:
• All MLEs — To reset all MLEs, press and hold both the ALL button in the Recall area
and the ALL button in the Store areas (Figure 2.9). Only the MLEs assigned to the
control panel are reset.
Figure 2.9 Press to Reset All MLEs at Once
789
456
123
+/-
0
.
BANK CLEAR ENTER
MLE
2
MLE
1
ALL
+4
MLE
4
MLE
3
MLE
2
MLE
1
RECALL
CLIP
ALL
MLE
4
MLE
3
FADE
RATE
MLE
RATE
EFF
RATE
KEY
RATE
UNDO
ATTRIB
KEYS
ONLY
EFF
DISS
GLOBAL MEMORY
Reset All Reset All