Ops 2–14 • Control Panel Introduction Vision Operator’s Manual (v12.0 MD)
3. The system will prompt you to confirm the restart. Once confirmed, the frame and
control panels power down and boot up again.
This completes the procedure for performing a full restart of the switcher.
Default State
When you reset an MLE, the entire switcher, or perform a complete restart, the switcher will
return to the default state.
All transition rates shown are for the indicated video format. The switcher automatically
calculates the transition rates, depending on the video format it is operating in
Note — If you reset an individual MLE, only that MLE will be returned to the default state. All
other MLEs will be unaffected.
The default state consists of the following:
• The first crosspoint button (Black by default) is selected on the Key, Background, and
Preset buses.
• All Keys will be taken off-air.
•In the Preview Bus Module, the PV and the MLE button for the Program/Preset MLE
are selected.
•In the Transition Modules, Background (BKGD) is selected as included in the next
transition, and Dissolve (DISS) is selected as the transition type.
Note — If the Default Transition Rate Active personality option is turned on, you must set the
default values from the Personality Menu. Refer to the section “Personality List” on page Eng
11-2 for more information.
•In the Effects Memory Module, the following memories and rates are set:
› REG:00 — Memory register 00 is preset
› Memory0 — Memory register 00 was last recalled
› MLE:015 — MLE transition rate is 15 frames (Interlaced at 59.94 Hz)
› Key:008 — Key transition rate is 8 frames (Interlaced at 59.94 Hz)
•In the Global Memory Module, the following memories and rates are set:
› REG:00 — Memory register 00 is preset
› Memory0 — Memory register 00 was last recalled
› M:015 — MLE transition rate is 15 frames (Interlaced at 59.94 Hz)
› D:008 — DSK transition rate is 8 frames (Interlaced at 59.94 Hz)
› F:20 — DSK fade-to-black transition rate is 20 frames (Interlaced at 59.94 Hz)
• Auto Select is selected as the key type in each Keyer.
• The Default MLE Map will be loaded.
To Next Page
Loading...
