Ops 17–22 • WARP Effects Vision Operator’s Manual (v12.0 MD)
Page Roll WARP
The Page Roll WARP allows you to roll up the key as you would a piece of paper. You can adjust
the angle, direction, and tightness of the roll.
Note — A Page Roll requires 2 Squeeze & Tease channel resources for all key types, even a
Preset Pattern key. A wipe created using a Page Roll will only require one Squeeze & Tease
channel resource.
Use the following procedure to set up a Page Roll WARP:
1. Select and activate the Page Roll WARP effect on the keyer you want to apply it.
2. Press Position on the S&T WARP Menu.
Page Roll (Position) — S&T WARP Menu
3. Adjust the appearance of the effect as follows:
•Use the Roll knob on the S&T WARP Menu, or the positioner, to adjust the
amount of the key that is rolled up.
•Use the Radius knob on the S&T WARP Menu, or the positioner, to adjust the
tightness of the roll.
•Use the Angle knob on the S&T WARP Menu, or the positioner, to adjust the
direction, or angle, that the roll is performed in.
4. Apply lighting to the Page Roll as follows:
• Press Light on the S&T WARP Menu.
Page Roll (Light) — S&T WARP Menu
•Use the Model knob on the S&T WARP Menu to select either a Natural (brighten
the highlight) or White (blends the highlight) light source.
To Next Page
Loading...
