Vision Operator’s Manual (v12.0 MD) Using the Menu System • Ops 3–9
Quick Navigation Buttons
The Quick Navigation buttons (Figure 3.7) allow you to control the display region next to the
buttons, or navigate to commonly used menus with a single button press. The additional Quick
Navigation buttons are displayed by pressing the Next Tab button. Refer to the section
“Touchscreen Interface” on page Ops 3-2 for more information on the buttons on the
Touchscreen Display.
The Quick Navigation buttons display the menu in the lower display region.
Figure 3.7 Quick Navigation Buttons
The default settings for these buttons are as follows:
First Tab
• Home — The Home button displays the Main Menu 1-2 on the adjacent display region.
• UP One — The Up One button displays the menu up one level in the menu tree.
• Hold — The Hold button locks the adjacent display region to the current menu.
• Next Tab — The Next Tab button toggles between the first and second tab of Quick
Navigation Buttons.
Second Tab
• Install — The Install button displays the Installation Menus.
• Pers — The Pers button displays the Personality Menu.
• Scheme — The Color Scheme button displays the Color Scheme Menus. From these
menus, you can set the color of the buttons on the control panel, as well as the skin used
for the menus.
• Diags — The Diag button displays the Panel Diagnostics Menu.
• Help — The Help button displays the welcome screen for the Online Help. If you have
already accessed the online help, this button will display the help at the same page that it
was last viewed. If you hold the Help button, and press another button on the control
panel, you can view specific help information on that button, or group of buttons. Refer
to the section “Help Features” on page Ops 3-11 for more information on using the help.
HOME
UP
ONE
HOLD
HOME
UP
ONE
HOLD
FRAME
FAIL
PANEL
FAIL
SYSTEM
POWER
EXIT
ENTER
DISPLAY
F2 F3 F4 F5 F6
MORE
F1
Quick Navigation Buttons
To Next Page
Loading...
