Ross Vision - Setting the Keyer Rate

Ops 5–10 • Transitions Vision Operator’s Manual (v12.0 MD)
2. Use the keypad in the center of the module to enter the new duration, in frames. The new
rate appears on the top line of the display as you enter it (Figure 5.15).
Figure 5.15 New MLE Rate — Effects Memory Module Display
3. Press ENTER on the Effects Memory Module to accept the new rate.
This completes the procedure for setting the MLE transition rate for an MLE.
Setting the Keyer Rate
The Keyer rate is set from the Effects Memory Module for all upper MLEs and Global Memory
Module for the Program/Preset MLE.
If the Crosspoint Group that you are setting the keyer rate on is assigned as an Aux Bus, the
keyer rate will set the key transition rate of the AuxKey.
Use the following procedure to set the keyer transition rate for an MLE:
1. Press KEY RATE on the Effects Memory Module for the MLE that you want to set the
keyer transition rate for (Figure 5.16).
Figure 5.16 Keyer Rate — Effects Memory Module
2. Use the keypad in the center of the module to enter the new duration, in frames. The new
rate appears on the top line of the display as you enter it (Figure 5.17).
Figure 5.17 New Keyer Rate — Effects Memory Module Display
3. Press ENTER on the Effects Memory Module to accept the new rate.
This completes the procedure for setting the keyer transition rate for an MLE.
New MLE rate:030
MLE:015 Key:008
RECALL
789
456
123
BANK
0
ENTER
KEYS
ONLY
EFF
DISS
STORE
MLE
RATE
KEY
RATE
E FFECTS M EMORY
EFF
RATE
ATTRIB
New Key rate:015
MLE:015 Key:008