Vision Operator’s Manual (v12.0 MD) Still-Store • Ops 9–3
Loading Stills
The switcher stores all the available still images on the hard drive. When you want to use one of
these stills on a still-store channel, you must select the channel, and then load the still into this
channel. This loads the still, or animation, into memory so that it is available when you select it.
A thumbnail of the still or animation appears on the menu to help to manage your stills.
Use the following procedure to load a still into a still-store channel:
1. Navigate to the Still-Store Menu as follows:
• Press HOME B Effects B Still Store.
Still-Store Menu 1-2
2. Select the still-store channel you want to load a still into as follows:
•Use the Location knob on the Still-Store Menu 1-2 to select Global-Store, or the
MLE X you want to select a channel on.
•Use the Channel knob on the Still-Store Menu 1-2 to select the channel you want
to load a still into. You can also select the channel box directly by pressing it.
3. Press Select/Manage on the Still-Store Menu.
4. Use the Contents knob on the Select Still Menu 1-2 to select the still, or directory, you
want to select. You can also select the still by pressing the icon on the menu. Directories
are indicated by a slash (/) at the end of the name.
Select Still Menu 1-2
Operating Tip — A yellow A in the upper left corner of the thumbnail indicates that the
original image has an alpha associated with it. A pink M in the upper right corner of the
thumbnail indicates that the original image is an animation.
To Next Page
Loading...
