EasyManua.ls Logo

Ross Vision - EMC Notices; General Handling Guidelines

Ross Vision
368 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
26. To reduce the risk of fire, replacement fuses must be the same type and rating.
27. Use only power cords specified for this product and certified for the country of use.
28. The safe operation of this equipment requires that the user heed and adhere to all
installation and servicing instruction contained within the equipment’s Engineering
Manuals.
29. For applicable V-100/V-100A Touchscreen Panel power supplies, see user instructions
contained within the Product’s Engineering Manual.
30. WAR NI NG: Batteries shall not be exposed to excessive heat such as sunshine, fire or
the like.
31. WAR NI NG: This product includes an “Ethernet Port” which allows this product to be
connected to a local area network (LAN). Only connect to networks that remain inside
the building. Do not connect to networks that go outside the building.
EMC Notices
United States of America
FCC Part 15
This equipment has been tested and found to comply with the limits for a class A Digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
Notice — Changes or modifications to this equipment not expressly approved by Ross Video
Limited could void the user’s authority to operate this equipment.
CANADA
This Class “A” digital apparatus complies with Canadian ICES-003.
Cet appariel numerique de la classe “A” est conforme a la norme NMB-003 du Canada.
EUROPE
This equipment is in compliance with the essential requirements and other relevant provisions of
CE Directive 93/68/EEC.
INTERNATIONAL
This equipment has been tested to CISPR 22:1997 along with amendments A1:2000 and
A2:2002, and found to comply with the limits for a Class A Digital device.
Notice — This is a Class A product. In domestic environments, this product may cause radio
interference, in which case the user may have to take adequate measures.
General Handling Guidelines
Careful handling, using proper ESD precautions, must be observed.

Table of Contents

Related product manuals