Ops 15–10 • Squeeze & Tease Sequences and Wipes Vision Operator’s Manual (v12.0 MD)
Saving and Loading Sequences and Wipes
Sequences can be saved, renamed, and loaded from the S&T MD Sequence Load/Save Menu.
The MLE and Keyer that a sequence is loaded onto is listed on the menu below the title, along
with the duration, number of keyframes, and number of channels of the selected sequence.
Note — If a sequence contains a hold, the time of the hold is not included in the Duration value
on the menu.
Saving and Naming a Sequence
You can save a sequence to any one of the 100 registers on the switcher. Once saved to a register,
you can rename the sequence to give it a more descriptive name.
Use the following procedure to save and name a sequence:
1. Press Load/Save Sequence on the S&T MD Sequence Menu 1-2.
S&T MD Sequence Load/Save Menu
2. Use the Sequence knob on the S&T MD Sequence Load/Save Menu to select a
register that you want to save the sequence to. Registers with a green dot next to them
already contain a sequence.
3. Press Save Sequence on the S&T MD Sequence Load/Save Menu to save the
sequence to the selected register.
4. Press Rename Sequence on the S&T MD Sequence Load/Save Menu.
Sequence Name Menu
To Next Page
Loading...
