Vision Operator’s Manual (v12.0 MD) Squeeze & Tease Sequences and Wipes • Ops 15–3
Creating a Sequence
A sequence is created by inserting keyframes of how you want the channel to appear, and how
long you want the switcher to take to move from one keyframe to the next. Each keyframe has a
duration that is used when the sequence is moving to that keyframe.
Use the following procedure to create a sequence:
1. Press the SEL button on the Keyers Module for the Keyer that you want to create a
sequence in. The S&T MD Position/Crop Menu 1-2 is displayed. The key must already
be flying.
2. Press Copy Up on the Lower Display Region to copy the S&T MD Position/Crop
Menu 1-2 to the Upper Display Region.
3. Press the DVE quick navigation button to display the S&T MD Main Menu 1-2 in the
Lower Display Region.
4. Press Sequence on the S&T MD Main Menu 1-2.
Operating Tip — If there is already sequence information loaded on the Keyer, you can
press Delete Workspace on the S&T MD Sequence Menu 2-2 to clear it.
5. Press Swap on the Lower Display Region to swap the S&T MD Position/Crop Menu
and the S&T MD Sequence Menu. Placing the S&T MD Position/Crop Menu in the
Lower Display Region allows you to use the positioner to adjust the channel.
S&T MD Sequence Menu and S&T MD Position/Crop Menu
Note — If you are creating a Squeeze & Tease wipe that uses WARP effects, you must apply
the WARP to all keyframes in the sequence. If you want to use the wipe as a Background
transition, start with the channel full screen.
To Next Page
Loading...
