Vision Operator’s Manual (v12.0 MD) Switcher Basics • Ops 4–39
Copy MLE
The Copy MLE function allows you to copy the entire contents of an MLE to another MLE. This
includes crosspoint selections, matte generator values, fader positions, on-air status, and key
active status.
The following rules apply to the Copy MLE function:
• If a re-entry selection is invalid on the destination MLE, black is automatically selected.
• If a transition type is invalid on the destination MLE, a dissolve is automatically selected.
• If a specific option is not installed on the destination MLE, the function is automatically
turned off.
• When copying from the Program/Preset MLE to another MLE, the downstream keyer
selections are converted into effect keyer selections.
• If a specific keyer was active in the source MLE, it becomes active in the destination.
Copy MLE Using Control Panel
You can copy the contents of one MLE to another quickly using the buttons on the Vision control
panel.
If you do not have a Panel Row assigned to the MLE you want to copy, or only have one Panel
Row, you can use the menu system to perform the copy. Refer to the section “Copy MLE Using
Menu” on page Ops 4-39 for more information.
Use the following procedure to copy the contents of one Panel Row to another:
1. Press and hold the BKGD button on the Transition Module on the destination Panel
Row (MLE).
2. Press the BKGD button on the Transition Module on the source Panel Row (MLE).
3. Release both buttons.
This completes the procedure for copying the contents of one MLE to another.
Copy MLE Using Menu
The menus can be used to copy the contents of an MLE to another, just like using the buttons on
the control panel.
Use the following procedure to copy the contents of one Panel Row to another:
1. Navigate to the MLE Copy Menu as follows:
• Press HOME B Attributes B Copy MLE.
Copy MLE Menu
To Next Page
Loading...
