Ops 14–2 • Picture Frame Borders Vision Operator’s Manual (v12.0 MD)
Border Size
The Border Size feature allows you to set the overall size of the border that is applied to the
channel. Borders are created from the outside edge of the channel, and expand inward.
Operating Tip — The size of the border should be set first in order to adjust the appearance
of the border.
As you adjust the size of the border, it expands inwards from the edge of the channel. The graphic
in the Size area of the menu displays the border in relation to the channel. The border is
represented by a solid line, and the channel is represented by a dashed line.
Use the following procedure to adjust the size of the border:
1. Press the SEL button on the Keyers Module for the Keyer that you want to adjust the
border size of the channel for. The S&T MD Position/Crop Menu 1-2 is displayed. The
key must already be flying.
2. Press the DVE quick navigation button to display the S&T MD Main Menu.
3. Press Border on the S&T MD Main Menu 1-2.
4. Press Size on the S&T MD Border Menu.
Size — S&T MD Border Menu
5. Use the Size knob on the S&T MD Border Menu, or the positioner, to adjust the size
of the border around the channel.
This completes the procedure for adjusting the size of the border.
To Next Page
Loading...
