Ops 12–14 • Squeeze & Tease Basic Operation Vision Operator’s Manual (v12.0 MD)
Frontside/Backside Video
Normally, when you rotate a flying key around to expose the backside, the video image shows as
a backwards representation of the displayed video signal (as if the backside of the key was
transparent). For a different effect, you may wish to have the back side of a flying key display a
different image than the front side.
Use the following procedure to adjust the frontside and backside video of a key:
1. Navigate to the Channel Management Menu as follows:
• Press CHNL MGMT on the Keyers Module to display the Channel Management
Menu 1-2.
• Press More.
2. Select the channel that you want to activate the Frontside/Backside video for as follows:
• Toggle the Channel 1 or Channel 2 button on the Channel Management
Menu 2-2 to On to activate the backside video for that channel.
Channel Management Menu 2-2
3. Select a video source for the backside video as follows:
•Use the Front knob on the Channel Management Menu 1-2 to select the
crosspoint for the front side.
•Use the Back knob on the Channel Management Menu 1-2 to select the
crosspoint for the back side.
4. Select an Auto Flip mode as follows:
•Use the Auto Flip knob on the Channel Management Menu 1-2 to automatically
flip the backside video when the image is rotated. If you rotate an image so that the
back is visible, the video appears backwards. You can choose between the
following:
› None — The backside video appears backwards when the image is rotated.
› H Flip — The video is flipped horizontally.
› V Flip — The video is flipped vertically.
› H-V Flip — The video is flipped both horizontally and vertically.
This completes the procedure for adjusting the frontside and backside video of a key.
To Next Page
Loading...
