Vision Operator’s Manual (v12.0 MD) Squeeze & Tease Basic Operation • Ops 12–13
• Chan 1 On Top — Channel 1 always appears in front of Channel 2.
• Chan 2 On Top — Channel 2 always appears in front of Channel 1.
Figure 12.14 Intersecting Channels
5. Press the lit SEL button on the Keyers Module to display the S&T MD Position Crop
Menu 1-2.
6. Press the Channel button on the S&T MD Position/Crop Menu 1-2 to highlight
channel 2. The number 2 appears red.
7. Set up your second fly key channel in the Keyer. You can switch back and forth between
Channels by pressing the Channel button on the S&T MD Position/Crop Menu 1-2.
Operating Tip — If you toggle the FLY KEY button Off, the channel that was assigned to the
Keyer will be released and available for use.
This completes the procedure for assigning two channels to the same Keyer.
Channel 1
Channel 2
V I S I O N
To Next Page
Loading...
