Ops 12–12 • Squeeze & Tease Basic Operation Vision Operator’s Manual (v12.0 MD)
Note — You can only fly 2 Preset Pattern (PST PATT) keys in the same Keyer at this time.
This applies to each Keyer in the MLE.
Use the following procedure to assign two channels to the same Keyer:
1. Set up your first fly key in the Keyer. This is the first channel, indicated by the red 1 on
the Channel button on the S&T MD Position/Crop Menu 1-2.
S&T MD Position/Crop Menu 1-2
Operating Tip — You can also press and hold the key type button and press the FLY KEY
button on the Keyers Module to add a channel to the Keyer.
2. Press CHNL MGMT on the Keyers Module to display the Channel Management
Menu 1-2.
Channel Management Menu 1-2
3. Toggle the Channel 2 button on the Channel Management Menu to On to assign a
second channel to the Keyer.
4. Use the Layering knob on the Channel Management Menu to select how you want
the channel to layer in the Keyer. You can choose between the following:
• Auto — Channel layering is determined based on the position, or depth, of each
channel in 3D space. This is the default setting.
• Intersecting — Both channels intersect. This allows you to have one channel slice
through the other (Figure 12.14).
Note — Using the Intersecting option with planes that are almost parallel to each other, or
with planes that have Aspect applied, may not produce the desired effect.
To Next Page
Loading...
