Ops 17–26 • WARP Effects Vision Operator’s Manual (v12.0 MD)
Ripple WARP
The Ripple WARP creates a ripple effect, like dropping a rock into a pool of water.
Use the following procedure to set up a Ripple WARP:
1. Select and activate the Ripple WARP effect on the keyer you want to apply it.
2. Press Wave on the S&T WARP Menu.
Ripple (Wave) — S&T WARP Menu
3. Adjust the waves of the effect as follows:
•Use the Amplitude knob on the S&T WARP Menu, or the positioner, to adjust the
perceived height of the waves.
•Use the Frequency knob on the S&T WARP Menu, or the positioner, to adjust
the number of waves.
4. Adjust the position of the center of the ripples as follows:
• Press Position on the S&T WARP Menu.
Ripples (Position) — S&T WARP Menu
•Use the Center (X) knob on the S&T WARP Menu, or the positioner, to
horizontally adjust the position of the center of the ripples.
•Use the Center (Y) knob on the S&T WARP Menu, or the positioner, to vertically
adjust the position of the center of the ripples.
To Next Page
Loading...
