Vision Operator’s Manual (v12.0 MD) Introduction • Ops 1–3
Documentation Conventions
The following conventions are used throughout this manual:
• Navigation procedures in this manual state the button you are to press, followed by the
menu that the button appears on. For example, the following navigation procedure shows
you how to navigate from the Main Menus to the Installation Menus. In this case, you
press More, and then Setup on the Main Menu 2-2, then you press Installation on the
Setup Menu 1-2.
› Press HOME B More B Setup B Installation.
• References in this manual to navigation buttons, such as HOME, UP ONE, and HOLD,
refer to the buttons on the Touchscreen Display located immediately to the left of the
Display Region that you are interacting with.
• Rear panel connectors are indicated in bold-faced upper case letters. For example:
› The AUX 1 connector is …
• Control Panel buttons are indicated in bold-faced upper case letters, using a sans-serif
font. For example:
› Press WIPE to …
• Menu names on the integral display panel are indicated in bold-faced text. For example:
› The Aux Bus Setup Menu allows you to …
• Softkey labels on the integral display are indicated in bold-faced text, using a sans-serif
font. They are not indicated by the function key below the display that you press. For
example:
› Press Accept New Name to register …
• Each module, or group of buttons, on the control panel is shown in bold-faced text. For
Example:
› Press the UNDO button in the Global Memory Module to ...
• The “Operating Tip” and “Note” boxes are used throughout this manual to provide
customers with additional useful information. For example:
Operating Tip — When the DHCP is set to On, you can use the Refresh button to poll the
server for the current network address information.
Note — If the DHCP option in On, the remaining settings are automatically configured. If the
DHCP is Off, you will have to manually enter values into all the fields.
To Next Page
Loading...
