Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–13
Lens Flare WARP
The Lens Flare WARP creates a point light source and a series of lens flare effects on the key
video. This WARP can be adjusted for position, lighting, color, and how the lens flares appear.
Use the following procedure to set up a Lens Flare WARP:
1. Select and activate the Lens Flare WARP effect on the keyer you want to apply it.
2. Press Position on the S&T WARP Menu.
Lens Flare (Position) — S&T WARP Menu
3. Adjust the center position of the light source for the lens flare as follows:
•Use the Center (X) knob on the S&T WARP Menu, or the positioner, to adjust the
horizontal position of the center point of the light source on screen.
•Use the Center (Y) knob on the S&T WARP Menu, or the positioner, to adjust the
vertical position of the center point of the light source on screen.
•Use the Size knob on the S&T WARP Menu, or the positioner, to adjust the size of
the light source and lens flares.
4. Adjust the light source of the effect as follows:
• Press Lighting on the S&T WARP Menu.
Lens Flare (Lighting) — S&T WARP Menu
•Use the Fade knob on the S&T WARP Menu to select Color to apply a washout
light to the key video.
•Use the Brightness knob on the S&T WARP Menu, or the positioner, to adjust
the brightness of the light source, flares, and washout light.
To Next Page
Loading...
