Vision Operator’s Manual (v12.0 MD) WARP Effects • Ops 17–3
Selecting a WARP Effect
To apply a WARP effect to a key you must select the MLE and Keyer that you want to apply the
effect to, select the effect, and then activate the WARP engine. The key must be flying.
Use the following procedure to select a WARP:
1. Press the SEL button on the Keyers Module for the Keyer that you want to apply the
WARP to. The S&T MD Position/Crop Menu 1-2 is displayed. The key must already
be flying.
Note — Squeeze & Tease MD WARP effects are applied full screen. If your key is not at full
screen, the WARP effect may not appear as expected or desired.
2. Press the DVE quick navigation button to display the S&T MD Main Menu 1-2.
3. Press More B WARP on the S&T MD Main Menu 2-2.
S&T WARP Menu
4. Use the Category knob on the S&T WARP Menu to select Favorites.
5. Use the WARP knob on the S&T WARP Menu to select the WARP you want to use.
6. Press Select on the S&T WARP Menu to activate the WARP.
This completes the procedure for selecting a WARP. Depending on the WARP you activated, you
will have to set up the parameters for the WARP.
To Next Page
Loading...
