Ops 3–8 • Using the Menu System Vision Operator’s Manual (v12.0 MD)
Using the Positioner with the Menu System
When you select specific installation and operational menus, Positioner Icons appear next to the
knobs (Figure 3.6) on the lower display region, indicating that moving the positioner in that axis
will adjust the selection for that knob. Typically, two or three icons are shown, depending upon
the selected menu and function.
When these icons appear, you can adjust the selected function or parameter either with the
Selection Knobs or with the Positioner.
Figure 3.6 The Positioner can be used to make selections on the menu system
• When the left-right positioner icon ( ) appears, you can move the Positioner left and
right to make adjustments to this value.
• When the up-down positioner icon ( ) appears, you can move the Positioner up and
down to make adjustments to this value.
• When the circular positioner icon ( ) appears, you can twist the Positioner knob
clockwise and counter-clockwise to make adjustments to this value.
For More Information...
• on using the positioner, refer to the section “Using the Positioner” on page Ops 4-37.
To Next Page
Loading...
