Ops 4–42 • Switcher Basics Vision Operator’s Manual (v12.0 MD)
Copy and Swap Keyers
The Copy and Swap Keyers functions allow you to copy the entire contents of a keyer to another
keyer, or multiple keyers.
Copy a Keyer Using Control Panel
The Copy Keyer function allows you to copy the entire contents of a Keyer to another Keyer in
the same MLE, or in a different MLE.
When you copy a keyer to another keyer, the entire contents of the source keyer is copied to the
destination, including the selected crosspoint and setting for all the key types. For example, if you
have an AUTO SELECT key enabled, the CHROMA KEY settings are also copied.
Use the following procedure to copy a keyer:
1. Press and hold any SEL button on the Effects Keyers Module for the keyer that you
want to copy the keyer to.
2. Press the SEL button on the Effects Keyers Module for the keyer that you want to
copy.
3. Release both buttons.
This completes the procedure for copying a keyer.
Copy and Swap Keyer Using Menu
The menus can be used to copy or swap the contents of a keyer to another, just like using the
buttons on the control panel. The contents of one source keyer can be copied to multiple
destination keyers. A swap can only be performed between two keyers.
Use the following procedure to copy or swap the contents of a keyer to another:
1. Navigate to the Copy Keyers Menu as follows:
• Press HOME B Attributes B Copy Keyers.
Copy Keyers Menu
2. In the Source area, select the keyer on the MLE that you want to copy or swap from.
3. In the Destination area, select the keyer, or keyers, you want to copy or swap to.
Note — You cannot have the same keyer selected for the Destination and Source to perform
a Copy. Only one Destination and one Source keyer can be selected to perform a Swap.
4. Perform the copy or swap as follows:
To Next Page
Loading...
