Ross Vision - Locking Memories

Ops 8–8 • Memory Functions Vision Operator’s Manual (v12.0 MD)
• on turning the Auto Recall feature on, refer to the section “Personality List” on
page Eng 11-2
.
• on memory attributes, refer to the section “MLE Memory Attributes” on page Ops
8-10.
Locking Memories
The Memory Lock feature allows you to protect memory registers from being changed or deleted.
With the memory lock enabled, you cannot overwrite the selected memory register until the
memory has been unlocked.
Memory registers can be locked or unlocked either from the menu system, or through the Global
Memory Module.
When working with locked memory registers, the following rules apply:
• If you try to store into a locked memory register, the keypad flashes and Memory X
LOCKED is shown in the display, along with the MLEs that the memory is locked on.
The MLE X buttons also flash, indicating the MLEs that the memory is locked on.
• If you lock a memory register, it is locked for all MLEs on the switcher.
• You can overwrite a locked memory register if you recall all memories from the hard
drive or USB flash drive.
• When you recall an individual memory from the hard drive or USB flash drive to a
memory register that is locked, you are prompted to overwrite the memory or cancel.
• If you store or recall a memory to the hard drive or USB flash drive, the lock status of the
memory is retained.
Locking Memories From the Menu System
Use the following procedure to lock or unlock a memory:
1. Navigate to the Memories Setup Menu as follows:
• Press HOME B Attributes B Memories Setup.
Memories Setup Menu
2. Select the memory register you want to lock as follows:
•Use the MLE knob on the Memories Setup Menu to select the MLE that you want
to lock the memory on.
•Use the Memory knob on the Memories Setup Menu to select the memory
register on the selected MLE that you want to lock. As you scroll through the
memory registers, the lock status of each memory register is indicated.
3. Lock an individual memory register as follows: