Ross Vision - Page 185

Vision Operator’s Manual (v12.0 MD) Memory Functions • Ops 8–9
• Toggle Locked on the Memories Setup Menu to On to lock the selected memory,
or Off to unlock the selected memory.
4. Lock or unlock all memory registers on a memory bank as follows:
• Press Lock Bank on the Memories Setup Menu to lock all memory registers on
the current bank.
• Press Unlock Bank on the Memories Setup Menu to unlock all memory registers
on the current bank.
This completes the procedure for locking or unlocking a memory.
Locking Memories from the Global Memory Module
Use the following procedure to lock or unlock a memory register from the Global Memory
Module:
1. Press and hold the Store ALL button on the Global Memory Module for a second.
2. Release the button when the Store ALL and Recall ALL buttons both light.
3. Select the Bank and Register for the memory register you want to lock or unlock. The
display shows the state, LOCKED or UNLOCKED, of the selected memory register.
4. Press the number corresponding to the memory register to toggle it between locked and
unlocked
5. Press ENTER on the Global Memory Module to save your settings.
This completes the procedure for locking or unlocking a memory register from the Global
Memory Module.
For More Information...
• on storing or recalling files on the hard drive or USB flash drive, refer to the section
“Storing and Recalling Files and Setups” on page Eng 13-4.