Ops 13–10 • Position/Crop Functions Vision Operator’s Manual (v12.0 MD)
Freeze
The Freeze effect pauses the video of the current channel, creating a temporary still. While the
video is frozen, you have complete control over the channel, including position and rotation.
If you are working with two combined channels with one frozen and one not, the Freeze effect is
unavailable and appears grayed out on the menu. Both channels must have the same Freeze state
to enable this effect when working with combined channels. The Freeze effect is always available
when you work with individual channels.
The Freeze effect is applied only to the currently selected channel. All other channels active on
that Keyer are unaffected.
Use the following procedure to freeze a video signal in a channel:
1. Press the SEL button on the Keyers Module for the Keyer that you want to apply freeze
to the channel for. The S&T MD Position/Crop Menu 1-2 is displayed. The key must
already be flying.
2. Press More.
Freeze — S&T MD Position/Crop Menu 2-2
3. Toggle Freeze on the S&T MD Position/Crop Menu 2-2 to On to freeze the video.
• Off — When the Freeze is off, the video for the current channel plays normally.
• On — When the Freeze is on, the video for the current channel is frozen.
Note — The “— Video Frozen —” is displayed for every channel that is frozen. If you select a
channel that is not currently frozen, this label is not displayed even if both channels are in the
same Keyer.
This completes the procedure for freezing a video signal in a channel.
To Next Page
Loading...
