Ross Vision - Global Memory Module

Ops 8–4 • Memory Functions Vision Operator’s Manual (v12.0 MD)
Global Memory Module
The Global Memory Module (Figure 8.4) of the bottom, Program/Preset MLE allows you to
store and recall memories on any MLE on the switcher.
Figure 8.4 Global Memory Module
In addition to storing and recalling memories, the Global Memory Module allows you to set the
Effects Dissolve, Fade to Black, MLE Transition, and DSK Transition rates for the MLE. Each
module consists of a display, a numeric keypad, and function buttons on either side of the keypad.
Display
The display on the Global Memory Module shows the current memory that is active for the
module, as well as the MLE and Key rates for the panel row.
Figure 8.5 Global Memory System Display
In the example shown (Figure 8.5), the active memory register (REG) is 24. This corresponds to
Memory 4, on Bank 2.
The second line of the display shows the current MLE, DSK, and Fade rates, in frames. In this
example, the MLE, or background transition, Rate is set to 15, the DSK Rate is set to 8, and the
Fade to Black Rate is set to 20.
Store and Recall Buttons
The Store and Recall buttons on the Global Memory Module allow you to select whether you
want to store a memory, or recall one. When working with either of these buttons, you can use the
Keys Only and Effects Dissolve buttons to apply these effects. These buttons are as follows:
• STORE ALL — The ALL button in the Store group allows you to use the keypad to
store a memory for all the crosspoint groups, or MLEs, on the switcher.
› MLE X — The MLE buttons located below the ALL button, where X is the number
of the MLE, allow you to store a memory to a specific panel row, or MLE.
• RECALL ALL — The ALL button in the Recall group allows you to use the keypad to
recall a memory for all the crosspoint groups, or MLEs, on the switcher.
› MLE X — The MLE buttons located below the ALL button, where X is the number
of the MLE, allow you to recall a memory to a specific panel row, or MLE.
• +4 — The +4 buttons allows you to select an MLE above MLE 4. When the +4 button is
toggled on, the MLE 1 through MLE 4 buttons become MLE 5 through MLE 8 buttons,
789
456
123
+/-
0
.
BANK CLEAR ENTER
MLE
2
MLE
1
MLE
4
MLE
3
MLE
2
MLE
1
ALL ALL
MLE
4
MLE
3
FADE
RATE
+4
MLE
RATE
EFF
RATE
KEY
RATE
UNDO
ATTRIB
KEYS
ONLY
RECALL
CLIP
EFF
DISS
GLOBAL M EMORY
RECALL STORE
REG:24 Memory24
M:0015 D:008 F:20