Ross Vision - Position

Vision Operator’s Manual (v12.0 MD) Position/Crop Functions • Ops 13–3
Position
The Position function allows you to adjust the position of the channel, or image, in the 3D
viewing area of the screen. You can use either the top, middle, or bottom knobs, or the positioner
to adjust the position of the channel.
Use the following procedure to adjust the position of a Squeeze & Tease channel:
1. Press the SEL button on the Keyers Module for the Keyer that you want to adjust the
position of the channel for. The S&T MD Position/Crop Menu 1-2 is displayed. The
key must already be flying.
2. Press Position on the S&T MD Position/Crop Menu 1-2.
Position — S&T MD Position/Crop Menu 1-2
3. Adjust the position of the channel in the 3D viewing space as follows:
•Use the X Location knob on the S&T MD Position/Crop Menu 1-2, or the
positioner, to adjust the horizontal position of the channel on the screen. A value of
1.000 or -1.000 is equal to one full screen width right or left, respectively, relative
to the center of the 3D view.
•Use the Y Location knob on the S&T MD Position/Crop Menu 1-2, or the
positioner, to adjust the vertical position of the channel on the screen. A value of
1.000 or -1.000 is equal to one full screen width up or down, respectively, relative
to the center of the 3D view.
•Use the Z Location knob on the S&T MD Position/Crop Menu 1-2, or the
positioner, to adjust the distance the channel is from the center point. A value of
1.000 or -1.000 is equal to one full screen width away or towards you, respectively,
relative to the center of the 3D view.
Note — You cannot change the size of the channel. You can only change the distance of the
channel from the center point.
This completes the procedure for adjusting the position of a channel. Refer to the following
sections for more information on adjusting the position of the channel in the 3D view.
For More Information...
• on using the positioner, refer to the section “Using the Positioner” on page Ops 4-37.