Ops 3–12 • Using the Menu System Vision Operator’s Manual (v12.0 MD)
Screen Captures
The Vision switcher allows you to take screen captures of the current state of the active menu.
Screen captures are stored to your removable USB flash drive.
Use the following procedure to capture the current state of the menu system:
1. Insert a USB flash drive into the USB port on the Fade to Black Module of the Vision
control panel.
2. Navigate to the menu you want to capture. The switcher will only capture the active, or
last used, menu.
3. Take a screen capture as follows:
• Press and hold the STORE ALL button on the Global Memory Module.
• Press the FADE RATE button on the Global Memory Module.
4. The control panel will beep and the file will be stored to the USB flash drive.
This completes the procedure for taking a screen capture.
To Next Page
Loading...
