Vision Operator’s Manual (v12.0 MD) Appendix A: Pre-loaded Effects • Ops 18–5
Copying Sequences to the Switcher
The sequences and wipes that are included with your Vision QMD/X switcher can be found on
the Product Resources CD. To copy the sequences to the switcher you must use the web interface
to load the sequences into a Setup on the switcher.
Use the following procedure to copy the sequences and wipes to you switcher:
1. On your computer, open your Web Browser and, in the address bar, enter the IP address
of your frame and press Enter. The QMD/X Web Interface Splash Screen is
displayed.
2. Enter your username and password as follows when the Login Dialog Box appears. The
default Name is user and Password is password.
3. Click File Sets to display the File Sets Page. All the populated Setups on the switcher
are shown in blue.
File Sets Page
4. In the Number field, enter the 2-digit number for the Setup on the switcher that you
want to copy the sequences to. If any Setup files exist in that location, they will be
replaced with the new files. All the populated Setups on the switcher are shown in blue.
5. In the Filename field, enter the location of the Sequences.tgz file on the computer.
Operating Tip — You can use the Browse... button to display the file browser dialog, and
then locate the file you want to upload.
6. Click Upload set and OK to copy the sequences to the switcher.
This completes the procedure for copying the sequences and wipes to your switcher. To load the
sequences on the switcher, you must recall the S&T MD Sequences from the Setup that you
copied the sequences to.
For More Information...
• on recalling sequences on the switcher, Refer to the section “Recalling Registers” on
page Eng 13-9.
To Next Page
Loading...
