Ross Vision - Transition Buttons

Ops 5–6 • Transitions Vision Operator’s Manual (v12.0 MD)
Operating Tip — Double-press the DISS button to set a WhiteFlash dissolve as the
transition type. The WhiteFlash Menu Setup is displayed.
For More Information...
• on the transition types, refer to the section “Transition Types” on page Ops 5-7.
• on running a sequence, refer to the section “Using Squeeze & Tease MD Wipes and
Sequences” on page Ops 15-13.
• on WhiteFlash, refer to the section “WhiteFlash” on page Ops 5-19.
Transition Buttons
The Transition buttons (Figure 5.7) allow you to perform a wipe, dissolve, or Squeeze & Tease
transition using the Auto Transition (AUTO TRANS) button or a cut using the Cut (CUT)
button. The progress of the auto transition is shown on the progress bar to the left of the fader
handle.
The rate at which the auto transition is performed is shown on the display to the right of the
AUTO TRANS button. The duration is shown in frames.
Figure 5.7 Transition Buttons — Transition Module (4-Keyer Shown)
Aside from transitions, the AUTO TRANS button can also be used to run a sequence. As with
performing a transition, the progress bar next to the fader handle lights up to show how far
through the sequence you are. When a sequence is selected, the display to the right of the AUTO
TRANS button shows the sequence rate in frames.
For More Information...
• on performing a transition, refer to the section “Performing Transitions” on page Ops
5-12.
BKGD
T RANSITION
KEY 1 KEY 2
ROLL
CLIP
PST
BKGD
TRANS
PV
KEY
PRIOR
TRANS
LIMIT
DISS WIPE DVE SEQ
KEY 3 KEY 4
BKGD
T
RAN
S
ITI
ON
KEY 1
K
EY
2
R
O
LL
C
LI
P
PS
T
BK
G
D
T
RAN
S
PV
KEY
P
RI
OR
TRAN
S
LIMIT
DI
SS
WIPE DVE
S
E
Q
K
EY
3
K
EY
4
FRAMES
CUT
AUTO
TRANS