Ops 13–12 • Position/Crop Functions Vision Operator’s Manual (v12.0 MD)
Viewpoint
The Viewpoint feature allows you to change the perspective, or point-of-view, of the channel on
the screen. This feature can be used to create an effect where the channel appears to have a
different vanishing point on the screen.
The graphic in the Viewpoint area of the menu displays the location of the viewpoint in relation
to the viewable area.
Use the following procedure to adjust the viewpoint of a channel:
1. Press the SEL button on the Keyers Module for the Keyer that you want to change the
viewpoint of the channel for. The S&T MD Position/Crop Menu 1-2 is displayed. The
key must already be flying.
2. Press More B Advanced Positioning on the S&T MD Position/Crop Menu 2-2.
3. Press Viewpoint on the S&T MD Advanced Positioning Menu.
Viewpoint — S&T MD Advanced Positioning Menu
4. Adjust the viewpoint of the channel as follows:
•Use the X Location knob on the S&T MD Advanced Positioning Menu to move
the viewpoint left or right along the X-Axis.
•Use the Y Location knob on the S&T MD Advanced Positioning Menu to move
the viewpoint left or right along the Y-Axis.
•Use the Z Location knob on the S&T MD Advanced Positioning Menu to move
the viewpoint left or right along the Z-Axis.
This completes the procedure for adjusting the viewpoint of a channel.
For More Information...
• on perspective and viewpoints, refer to the section “Working in 3D Space” on page Ops
12-3.
To Next Page
Loading...
