Vision Operator’s Manual (v12.0 MD) Position/Crop Functions • Ops 13–11
Spin
The Spin feature allows you to rotate a channel in 3D space relative to the fixed reference frame
of the screen, as opposed to a Pivot Point on the channel itself.
Operating Tip — If you are using the Spin feature in a sequence, you must choose Spin as
the rotation type for that sequence.
The graphics in the Position and Point of Rotation areas of the menu display the spin of the
channel in relation to the viewable area.
Use the following procedure to adjust the spin of a channel:
1. Press the SEL button on the Keyers Module for the Keyer that you want to apply spin
to the channel for. The S&T MD Position/Crop Menu 1-2 is displayed. The key must
already be flying.
2. Press More B Advanced Positioning on the S&T MD Position/Crop Menu 2-2.
3. Press Spin on the S&T MD Advanced Positioning Menu.
Spin — S&T MD Advanced Positioning Menu
4. Adjust the spin of the channel as follows:
•Use the X Spin knob to spin the channel around the X-Axis of the screen.
•Use the Y Spin knob to spin the channel around the Y-Axis of the screen.
•Use the Z Spin knob to spin the channel around the Z-Axis of the screen.
This completes the procedure for adjusting the spin of a channel.
For More Information...
• on working with sequences, refer to the section “Using Squeeze & Tease MD Wipes
and Sequences” on page Ops 15-13.
To Next Page
Loading...
