Vision Operator’s Manual (v12.0 MD) Peripheral Control • Ops 10–19
Editor Interface Control
The editor interface allows the Vision switcher to be controlled by an external editor. The status
of the Editor Interface is shown on the Main Menu under Remote Enables and can be turned on
or off from the Remote Enables Menu.
Use the following procedure to turn the Editor Interface on or off:
1. Navigate to the Remote Enables Menu as follows:
• Press HOME B More B Remote Enables.
Remote Enables Menu
2. Toggle Editor on the Remote Enables Menu to On to allow an editor to control the
switcher, or Off to turn off the Editor Interface.
Note — If the switcher does not have the same bus map assigned to every bus (MLE
Program/Preset, Keyers, Utility), an error message is displayed on the Main Menu indicating
the bus map mismatch.
This completes the procedure for turning the Editor Interface on or off.
To Next Page
Loading...
