Ops 15–14 • Squeeze & Tease Sequences and Wipes Vision Operator’s Manual (v12.0 MD)
7. Perform the transition using the fader, or by pressing the AUTO TRANS or CUT button
on the Transition Module.
This completes the procedure for performing a Squeeze & Tease MD wipe transition.
For More Information...
• on how to set up and perform a transition, refer to the section “Performing Transitions”
on page Ops 5-12.
• on the pre-loaded patterns, refer to the section “Squeeze & Tease MD Wipes and
Sequences” on page Ops 18-2.
Running a Sequence
A Sequence can be performed only on a Keyer that is flying a key. Unlike the Squeeze & Tease
wipes, sequences do not perform transitions.
You can set a default sequence rate that is used when an MLE, or the switcher, is defaulted. This
rate overrides the duration stored in the sequence.
Use the following procedure to run a sequence:
1. Select the video sources on the buses that you want to transition.
2. Select a Keyer as the next transition on the Transition Module of the MLE.
3. Press the SEQ button on the Transition Module to display the S&T MD Wipe List
Menu.
Sequence — S&T MD Wipe List Menu
4. Select the sequence you want to use for the transition on the S&T MD Wipe List Menu.
5. Toggle Direction on the S&T MD Wipe List Menu to select either Rev or Fwd. The
sequence runs either forward, going from the first keyframe to the last, or in reverse,
going from the last keyframe to the first.
6. Toggle Flip Flop on the S&T MD Wipe List Menu to select either On or Off. With
Flip/Flop toggled On, the sequence runs forward and then reverse.
7. Adjust the sequence as follows:
• Press Modify Sequence on the S&T MD Wipe List Menu.
• Adjust the sequence as required. Refer to the section “Modifying Multiple
Keyframes” on page Ops 15-7 for more information on modifying a sequence.
8. Run the sequence using the fader, or by pressing the AUTO TRANS or CUT button on
the Transition Module.
This completes the procedure for running a sequence.
To Next Page
Loading...
