Vision Operator’s Manual (v12.0 MD) Squeeze & Tease Sequences and Wipes • Ops 15–13
Using Squeeze & Tease MD Wipes and Sequences
Once you have created and saved your sequence, you can use it either as a sequence on a Keyer,
or as a transition on a Keyer or Background. The sequence is selected either through the Pattern
Selection Menu, or by entering the sequence number on the keypad.
Running a Squeeze & Tease MD Wipe Transition
A Squeeze & Tease Wipe can be performed on either a Keyer or a Background, depending on the
number of available Squeeze & Tease channel resources.
Note — The switcher dynamically allocates Squeeze & Tease channel resources to produce
the wipe effect. If there are not enough channel resources available, a dissolve is performed
instead.
Use the following procedure to perform a Squeeze & Tease MD wipe transition:
1. Select the video sources on the buses that you want to transition.
2. Select Background or a Keyer as the next transition on the Transition Module of the
MLE.
3. Press the DVE button on the Transition Module to display the S&T MD Wipe List
Menu.
Operating Tip — When you press DVE on the Transition Module, 3D MLEx WIPE# is
shown on the display of the Global Memory Module. Enter the number of the sequence you
want to load using the keypad on the Global Memory Module and press ENTER to load the
sequence.
Wipe — S&T MD Wipe List Menu
4. Select the sequence you want to use for the transition on the S&T MD Wipe List Menu.
Note — The Direction and Flip Flop features are only available for background transitions.
The buttons are gray if a key only transition is selected.
5. Toggle Direction on the S&T MD Wipe List Menu to select either Rev or Fwd. The
sequence runs either forward, going from the first keyframe to the last, or in reverse,
going from the last keyframe to the first.
6. Toggle Flip Flop on the S&T MD Wipe List Menu to select either On or Off. With
Flip/Flop toggled On, the sequence will run forward and then reverse.
To Next Page
Loading...
