Ops 6–4 • Wipes, Patterns, Washes, and Mattes Vision Operator’s Manual (v12.0 MD)
Operating Tip — If you want to add a border to the wipe, press Modify Pattern B Size/Soft
Border and increase the border size. Refer to the section “Border Size and Softness” on page
Ops 6-7 for information on adjusting a border.
8. Perform the transition using the fader, or by pressing the AUTO TRANS button on the
Transition Module.
This completes the procedure for performing a wipe transition.
Assigning User Wipes
The User Wipe feature allows you to select from the pre-loaded additional wipes and assign them
to the user wipe buttons. The user wipe buttons are essentially presets that can be programmed to
your favorite patterns. Once set up, the user wipe button operates in the same manner as any of
the other wipe pattern buttons.
Use the following procedure to assign a wipe pattern to a user wipe button:
Note — Pattern modifiers cannot be applied to user wipes. You must use memories to store
pattern modifiers with the user wipe.
1. Navigate to the User Wipes Menu as follows:
• Press HOME B Effects B Pattern Selection B Modify Pattern B More
B Pattern Options B User Wipes.
User Wipes Menu
2. Use the User Wipe knob on the User Wipes Menu to select the user wipe button (1
through 8) that you want to assign the wipe pattern to.
3. Use the Category knob on the User Wipe Menu to select the category of wipe you
want to assign to the user wipe button.
4. Use the Pattern knob on the User Wipe Menu to select the wipe pattern that you want
to assign to the selected user wipe button.
This completes the procedure for assigning a wipe pattern to a user wipe button.
For More Information...
• on transitions, refer to the section “Performing Transitions” on page Ops 5-12.
• on the pre-loaded patterns, refer to the section “Squeeze & Tease MD Wipes and
Sequences” on page Ops 18-2.
• on the different categories and wipes available, refer to the section “Standard Wipes” on
page Ops 18-6.
To Next Page
Loading...
