Ops 17–34 • WARP Effects Vision Operator’s Manual (v12.0 MD)
Stretch WARP
The Stretch WARP allows you to stretch the key both horizontally and vertically.
Use the following procedure to set up a Stretch WARP:
1. Select and activate the Stretch WARP effect on the keyer you want to apply it.
2. Press Aspect on the S&T WARP Menu.
Stretch (Aspect) — S&T WARP Menu
3. Use the X Aspect knob on the S&T WARP Menu, or the positioner, to adjust the size
of the key horizontally.
4. Use the Y Aspect knob on the S&T WARP Menu, or the positioner, to adjust the size
of the key vertically.
This completes the procedure for setting up a Stretch WARP.
To Next Page
Loading...
