Vision Operator’s Manual (v12.0 MD) Still-Store • Ops 9–15
Managing Stills
Still Management allows you to create and delete directories and, rename, renumber, delete, and
move stills.
Renaming and Renumbering Stills
Once a still-store image has been transferred onto the switcher, you can change the name or ID
number of the still.
Use the following procedure to rename or renumber a still:
1. Navigate to the Still-Store Menu as follows:
• Press HOME B Effects B Still Store.
2. Press Select/Manage on the Still-Store Menu 1-2.
3. Use the Contents knob on the Select Still Menu 1-2 to select the still you want to
rename or renumber. Directories are indicated by a slash (/) at the end of the name.
4. Press On-Air Properties on the Still-Store Menu 1-2.
5. Press Rename/Renumber on the Still-Store Properties Menu.
Rename/Renumber Still Menu
Operating Tip — Refer to the section “Using the Naming Menus” on page Eng 5-16 for
more information on using the Rename/Renumber Still Menu to enter a name.
6. Enter the new name for the still in the New Name field. The name can be no more than
8 characters in length and must be unique.
7. Renumber the still as follows:
• Enter a new number in the keypad on the Global Memory Module. If the number
is already being used, you must renumber that still before you can use the number
for the current still.
• Press ENTER on the Global Memory Module.
This completes the procedure for renaming or renumbering a still.
To Next Page
Loading...
