Vision Operator’s Manual (v12.0 MD) Transitions • Ops 5–19
WhiteFlash
The WhiteFlash feature allows you to perform a two-step transition where a dissolve to and from
white, or other selected color, is performed in the middle of the transition (Figure 5.27). The
video signal on the Background bus is transitioned to a Color Background of the selected
WhiteFlash color. The Color Background is then transitioned to the Preset bus. WhiteFlash
consumes a background generator for the transition.
Figure 5.27 WhiteFlash Transition — Program Output
Setting Up a WhiteFlash Transition
A WhiteFlash transition is performed just like a normal dissolve, except that you must set the
color for the flash, and the rates for the onset, hold, and fade.
Use the following procedure to set up a WhiteFlash transition:
1. Navigate to the WhiteFlash Menu as follows:
• Press HOME B Effects B More B More B WhiteFlash
WhiteFlash Setup Menu
2. Toggle Whiteflash to Yes on the WhiteFlash Setup Menu to activate WhiteFlash.
3. Double-press DISS on the Transition Module. The DISS button on the Transition
Module flashes, indicating that WhiteFlash is set as the transition type.
4. Toggle the MLE Rate to Yes or No to use the transition rate for the MLE as the
WhiteFlash rate.
• Yes — Select this option to use the MLE Rate as the transition rate for the
WhiteFlash. The Onset, Hold, and Fade rates represent proportional values of the
total MLE Rate.
• No — Select this option to not use the MLE Rate as the transition rate for the
WhiteFlash. The Onset, Hold, and Fade rates are the number of frames for each
part of the WhiteFlash. The MLE Rate is not used for this transition.
5. Set the Onset, Hold, and Fade rates as follows:
To Next Page
Loading...
