Ops 5–18 • Transitions Vision Operator’s Manual (v12.0 MD)
Note — Because a transition limit stops a transition before it completes, a transition that uses a
transition limit does not transition to the next shot. The transition progresses part-way through
the transition, and then returns to the original point.
Use the following procedure to use a transition limit:
1. Ensure that a transition limit has been set for the MLE that you are performing a
transition on.
2. Ensure that the fader handle is at one of the limits.
3. Select TRANS LIMIT on the Transition Module for the MLE that you want to perform
the transition limit on. The button lights up, indicating that the next transition will stop at
the transition limit.
4. Press AUTO TRANS on the Transition Module to perform the transition. The
transition stops at the transition limit.
5. Press AUTO TRANS on the Transition Module to perform the second part of the
transition. The transition progresses back to the starting point.
This completes the procedure for using a transition limit.
To Next Page
Loading...
