Ops 5–22 • Transitions Vision Operator’s Manual (v12.0 MD)
4. Set the next key priority as follows:
• Press the Key X button in the Next area for the desired keyer at the layer you want
the key to appear, where X is the number of the keyer. The remaining keys shift
layers to accommodate the change. Keys at the same layer, or above, the selected
layer are shifted up.
Note — A Key Priority transition can only be performed when all affected keyers are on-air, or
active on the MLE, with a DISS or WIPE. A Squeeze & Tease transition cannot be used for a
key priority transition.
5. Press CUT or AUTO TRANS, or use the fader, to perform the key over transition.
This completes the procedure for performing a key priority transition. Remember to deselect
KEY PRIOR on the Transition Module when you have completed your key priority transitions.
For More Information...
• on key priority, Refer to the section “Video Layering” on page Ops 4-3.
Manual Key Priority Cuts
You can manually set the key priority for the keyers from the Transition and Keyers Modules.
Manually changing the key priority effects the Current key priority, and cannot be applied with a
key priority transition.
Use the following procedure to manually set key priority:
1. Press and hold the KEY PRIOR button on the Transition Module.
2. Press the SEL button for Keyer 3 on the Keyers Module. This places Key 3 on top of
all the other keys.
3. Press the SEL button for Keyer 2 on the Keyers Module. This places Key 2 on top of
all the other keys, including Key 3.
4. Both Key 1 and Key 4 remain in their original order, with Key 4 on top of Key 1
(Figure 5.28).
Figure 5.28 New Keyer Priority
5. Release the KEY PRIOR button.
This completes the procedure for manually setting key priority.
To Next Page
Loading...
